Calyston demo — Dashboard

This is Calyston’s actual interface — a fresh install, before any camera is added. Nothing is a mock-up: navigate the tabs, open the dialogs, run a network scan. Saving is disabled. ← Back to calyston.com

Live cameras · 00 of 04 slots

community

Cameras 0 / 4

Retention max 14d

🔒 16 cameras Pro Upgrade

🔒 AI object detection Pro Upgrade

🔒 AI video search Pro Upgrade

🔒 Mobile push alerts Pro Upgrade

Try Pro free for 14 days Start free trial → No credit card required.

Remote Access via Tailscale

CAMERA DISABLED enable from settings to stream

Motion sensitivity

⚠ Motion needs a low-res substream and this camera doesn't have one set — no motion or AI events will be generated (recording is unaffected). Set the substream URL in Settings → Cameras; most brands expose one and it's auto-filled when the camera is added by discovery.

⚠ Motion can't decode this camera's substream — no motion or AI events are being generated (recording is unaffected). This usually means an H.265/HEVC substream: switch the substream codec to H.264 in the camera's own settings and motion recovers on its own.

ⓘ Motion is the trigger for AI Detection on this camera — it can't be turned off while detection is on.

Advanced

Raw sensitivity:

Motion area

Motion source

Object detection

Min confidence:

Zones

Alert rules

feed dash push

ⓘ feed — highlights the event in the Events page · dash — live alert on the dashboard while you're watching · push — sends to your phone (Telegram / Discord / ntfy — set up in Settings → Notifications; respects Arm/Disarm and quiet hours). The number is the cooldown: minimum seconds between alerts from this rule.

Push notifications

Notification Schedule

Push is suppressed during the periods below while the camera is armed.

Status

Retention

Protocol RTSP

Motion

RTSP source

Motion source

Created

Full live Playback

Connect

Verify

3 Name

On another subnet? Scan an IP range:

No cameras answered on that range. Check the range, or that the VMS can route to it.

Not listed? Enter the camera IP:

Camera URL (RTSP)

Paste the full RTSP URL the camera exposes.

Substream URL — required for motion

Motion and AI detection run only on this low-res stream — without it the camera still records, but generates no events. Auto-filled from your camera URL when the brand is recognized.

Username (optional)

Password (optional)

RTSP

CONNECTED · ·

Display name

Shown on the dashboard tile and in event records. Uppercased on save.

ENABLE IMMEDIATELY

ARM MOTION DETECTION

Results for “”

Confirm your password